Calendario

Julio 2017
LunMarMierJueVierSabDom
 << < > >>
     12
3456789
10111213141516
17181920212223
24252627282930
31      

Anuncio

¿Quién está en línea?

Miembro: 0
Visitantes: 6

rss Sindicación

25 Avr 2017 - 18:10:13

Sauer Danfoss (Turolla) Gear Pumps

Sauer Danfoss (Turolla) Gear Pumps


Before backpacking the Appalachian Trail (<-my journal), I'd carried out a variety of mountain climbing, however the majority of those trips had lasted a day or two at most. After engagement, controlled by a limit change, the full stress from the turning gear pump is provided to the radial piston motor turning the shaft with full turning gear pace. Two solenoid valves, one for creep velocity and the other for full velocity, control the turning gear oil supply. The turning gear pump and the jacking oil pump are pushed by one frequent AC motor.


Gear pumps are simple, durable and cheap pumps which can be suitable for pressures under 20 MPa (3,000 psi). These pumps fall underneath optimistic displacement, which implies that they pump a gentle amount of fluid for every cycle. The liquid is then trapped by the gear tooth and compelled out to the outlet in the course of the discharge stroke. For lubrication, the gear pump utilises a small quantity of oil that comes from the pressured facet of the gears that flows through the hydrodynamic bearings and expels the identical oil to the part of the gears with low strain.


The jacking oil system and the turning gear system belong to the identical function group controller. Turning gear operation without jacking oil switched on isn't allowed, as a result of the bearings could be damaged as a result of inadequate lubrication. Case of an emergency the turning gear system may be switched-off for a maximum of 15 minutes after one day and half-hour after 2 days steam turbine shut-down. Examples shown are group three gear pump series SNP3/SNP3NN (on the left) and group 2 gear pump collection SNP2/SNP2NN (on the right). The strain balanced design of the pumps supplies excessive effectivity for all the sequence.


After engagement, controlled by a limit switch, the complete strain from the turning gear pump is equipped to the radial piston motor turning the shaft with full turning gear speed. Two solenoid valves, one for creep velocity Hydraulic filter elements and the other for full pace, control the turning gear oil supply. The turning gear pump and the jacking oil pump are pushed by one frequent AC motor.


So, if you are on the lookout for environment friendly submersible pumps , water pumps and different pumps in Australia, then you should rent reliable pump providers. Pump Options Australasia are importers and distributors of quality European pumps and filters. Jacking oil system protects the turbines journal bearings throughout begin-up and shut-down. Turning gear system rotates the turbine shaft so that it'll not bend, as a result of uneven temperature distribution. Turning gear pump is an axial piston kind, which is positioned on the lube oil tank.
Admin · 9140 vistas · Escribir un comentario

Vínculo permanente hacia el artículo completo

http://handscars3619.hazblog.com/Primer-blog-b1/Sauer-Danfoss-Turolla-Gear-Pumps-b1-p346.htm

Comentarios

Este artículo no tiene Comentario por el momento .....


Escribir un comentario

Estatuto de los nuevos comentarios: Publicado





Se mostrará tu URL


Por favor introduce el código contenido en las imágenes.


Texto del comentario

Opciones
   (Salvar el nombre, el mail y la URL en los cookies)