Calendario

Septiembre 2017
LunMarMierJueVierSabDom
 << < > >>
    123
45678910
11121314151617
18192021222324
252627282930 

Anuncio

¿Quién está en línea?

Miembro: 0
Visitantes: 4

rss Sindicación

25 Avr 2017 - 18:07:11

Overview Of Jacking Oil System

Sauer Danfoss (Turolla) Gear Pumps


Prevents steel to metal contact within the journal bearings by producing a hydrostatic oil movie when the rotational shaft speed is too low to create a continuous hydrodynamic oil movie. So, in case you are looking for environment friendly submersible pumps , water pumps and different pumps in Australia, then you must rent dependable pump suppliers. Pump Options Australasia are importers and distributors of high quality European pumps and filters. Jacking oil system protects the turbines journal bearings throughout begin-up and shut-down. Turning gear system rotates the turbine shaft so that it'll not bend, attributable to uneven temperature distribution. Turning gear pump is an axial piston type, which is located on the lube oil tank.


So, if you're searching for environment friendly submersible pumps , water pumps and different pumps in Australia, then it is best to rent dependable pump providers. Pump Solutions Australasia are importers and distributors of high quality European pumps and filters. Jacking oil system protects the turbines journal bearings during begin-up and shut-down. Turning gear system rotates the turbine shaft so that it'll not bend, due to uneven temperature distribution. Turning gear pump is an axial piston kind, which is located on the lube oil tank.


After engagement, controlled by a limit swap, the complete pressure from the turning gear pump is equipped to the radial piston motor turning the shaft with full turning gear velocity. Two solenoid valves, one for creep pace and the other for full velocity, control the turning gear oil provide. The turning gear pump and the jacking oil pump are pushed by one common AC motor.


The jacking oil system and the turning gear system belong to the same function group controller. Turning gear operation with out jacking oil switched on is not allowed, as a result of the bearings may be broken on account of inadequate lubrication. Case of an emergency the turning gear system may be switched-off for a most of quarter-hour after one Gear pumps day and half-hour after 2 days steam turbine shut-down. Examples shown are group three gear pump sequence SNP3/SNP3NN (on the left) and group 2 gear pump collection SNP2/SNP2NN (on the best). The strain balanced design of the pumps offers excessive effectivity for the entire collection.


Engage the drive pinion, a solenoid valve is activated, which exerts lube oil stress on the piston of the drive pinion. On the same time, creep velocity operation of the radial piston motor is started by the pressure from the strain diminished oil from the turning gear pump to guarantee engagement of the drive pinion. Then the engagement solenoid valve is switched off, the turning gear stays engaged by the optimistic torque of hydraulic motor.
Admin · 13 vistas · Escribir un comentario

Vínculo permanente hacia el artículo completo

http://handscars3619.hazblog.com/Primer-blog-b1/Overview-Of-Jacking-Oil-System-b1-p345.htm

Comentarios

Este artículo no tiene Comentario por el momento .....


Escribir un comentario

Estatuto de los nuevos comentarios: Publicado





Se mostrará tu URL


Por favor introduce el código contenido en las imágenes.


Texto del comentario

Opciones
   (Salvar el nombre, el mail y la URL en los cookies)