Calendario

Junio 2017
LunMarMierJueVierSabDom
 << < > >>
   1234
567891011
12131415161718
19202122232425
2627282930  

Anuncio

¿Quién está en línea?

Miembro: 0
Visitantes: 8

rss Sindicación

25 Avr 2017 - 18:06:26

How To Maintain Gear Pumps

How To Preserve Gear Pumps


Sauer Danfoss gear pumps equipped by P&R Hydraulics Ltd 01603 424880 - P&R Hydraulics Ltd is an official Sauer Danfoss distributor and might supply a spread of hydraulic elements. The lube oil provide downstream of the lube oil filter feeds the turning gear pump, which is driven by the identical AC-Motor that drives the jacking oil pump. Oil that is discharged from the pump is guided to the frequent turning gear housing, which consists of an axial movable drive pinion, a coupled radial piston motor and a management block. Piston moves axially against a spring drive in the path of the gear rim on the turbine shaft.


So, if you're looking for environment friendly submersible pumps , water pumps and different pumps in Australia, then it's best to rent reliable pump suppliers. Pump Options Australasia are importers and distributors of high quality European pumps and filters. Jacking oil system protects the turbines journal bearings during begin-up and shut-down. Turning gear system rotates the turbine shaft so that it will not bend, attributable to uneven temperature distribution. Turning gear pump is an axial piston type, which is situated on the lube oil tank.


After engagement, controlled by a restrict swap, the total stress from the turning gear pump is provided to the radial piston motor turning the shaft with full turning gear speed. Two solenoid valves, one for creep pace and the other for full pace, management the turning gear oil supply. The turning gear pump and the jacking oil pump are driven by one widespread AC motor.


The jacking oil system and the turning gear system belong to the same perform group controller. Turning gear operation with out jacking oil switched on will not be allowed, because the bearings might be damaged due to inadequate lubrication. Case of an emergency the turning gear system could also be switched-off for a maximum of 15 minutes after at some Hydraulic filter elements point and half-hour after 2 days steam turbine shut-down. Examples shown are group 3 gear pump series SNP3/SNP3NN (on the left) and group 2 gear pump series SNP2/SNP2NN (on the correct). The stress balanced design of the pumps gives high effectivity for the complete sequence.


Turolla OCG excessive efficiency gear pumps are fastened displacement pumps which include the pump housing, drive gear, pushed gear, DU bushings, rear cowl and front flange, shaft seal and internal/outer seals. For those who fill the gearbox from the top gap, except you are VERY FORTUNATE you'll get an air lock in the gearbox, this will probably be a giant bubble of air that takes up the house required for the gear oil to fill.

Vínculo permanente hacia el artículo completo

http://handscars3619.hazblog.com/Primer-blog-b1/How-To-Maintain-Gear-Pumps-b1-p344.htm

Comentarios

Este artículo no tiene Comentario por el momento .....


Escribir un comentario

Estatuto de los nuevos comentarios: Publicado





Se mostrará tu URL


Por favor introduce el código contenido en las imágenes.


Texto del comentario

Opciones
   (Salvar el nombre, el mail y la URL en los cookies)